OnSite III Allergen Lateral Flow Tests - Almond

OnSite® III Allergen Lateral Flow Tests – Almond is designed for use in the qualitative determination of almond residues obtained from sampling foods (solids, powders, and liquids) and surfaces. Almonds, in combination with other tree nuts, constitute a relatively common cause of food allergy, capable of triggering severe allergic reactions in sensitive individuals. Accordingly, food labeling laws in many countries require food labels to clearly indicate almond content. To assist the food industry in establishing effective food safety practices, this test is a rapid test to reliably detect almond residues in food and on surfaces and equipment.

The Almond OnSite® III Allergen Kits consist of lateral flow devices (LFDs) that can be used to rapidly detect allergens in foods, rinse water and environmental surfaces (see link below to order). The LFDs are configured using antibodies that have been raised against the target allergen. To operate the kit, the sample is collected using the supplied scoop and then extracted for 2 min by shaking at room temperature. The tube is allowed to settle for 5 min by resting it. Thereafter, the sample extract is applied to the LFD using a dropper supplied with the kit. The fluid is wicked across the reagent zone, which includes a procedural control line (C), an overload line (O), and a test line (T). The inclusion of an overload line (O) is critical for testing foods that have high analyte contamination to prevent misinterpretation of false negative test outcomes.

Key Features

• Limit of Detection: Detects almond allergens down to 1.0 ppm in food and rinse water and down to 1.0 µg/100 cm2 on environmental surfaces.
• Assay Time: ~ 20 min.
• Cross-Reactivity: Cross-reactivity with kidney bean, low level with poppy seed.
• Kit Components: OnSite® III LFD Devices (10), Single-Use Dropper (10), Breakaway Swabs (10), Pre-Measured OnSite® LFD Extraction Buffer (10), Instructions for use
• The test outcome is interpreted by visualizing the appearance of three lines at 15 min.
• Environmental surface testing requires separate purchase of the OnSite® Allergen Accessory Kit

The test is intended for laboratory use only and should only be performed by trained personnel.